![]() Just be careful not to apply too much or the inletting will be too tight to fit on the rifle.Īllow approximately one hour to dry, then sand with extra-fine sandpaper. This will act as a barrier to seal out oil and moisture. If you wish, a thin coat may also be applied to the inletted areas and under the buttplate. Using a small paint brush, apply a moderately heavy coat to all outside stock surfaces, making sure all pores are filled. Mix the Filler/Sealer well to be sure all the filler is suspended in the mixture. Unlike common "hardware store" filler/sealer, it sands easily without gumming.īe sure the stock is free of all sanding dust. Precision Gun Works Clear Filler/Sealer is lacquer-based, and is especially easy to work with. With close scrutiny, you will have a stock that will exactly match the contours of the original. Be careful not to remove too much wood from the center portion of the stock as most stocks were originally shaped to have a slight bulge or "fish belly" in the middle, smoothly tapering outward to the ends. The goal is to obtain a smooth, even finish with all contours flowing nicely, one into another. When filing and shaping, it is helpful to sight down the stock from end to end to avoid dips or bulges. Using a file, shape or "feather" the wood from the edges inward to obtain the proper finished shape. To avoid marring the finish of the metal, this step is best performed with the stocks removed from the rifle. Very carefully file away excess wood to a point just above this line. Using a pencil with a very fine point, mark around all metal surfaces which come into contact with the wood. Once the stocks have been fitted, drill the necessary holes and secure the stocks to the rifle and buttplate. Also helpful is a bench vise, with padded jaws, for securely holding the stock while filing and drilling holes. We include both straight and rounded carving tools in our Deluxe Stock Finishing Kit.Īn electric drill and the proper sizes of bits (preferably brad point) are needed for drilling the various screw holes. Lacking this, you can also use a sharp, fine-pointed knife. Also very helpful is a half-round bastard cut file (also included in our Deluxe Finishing Kit) for fitting the buttplate and shaping the comb area of the stock.įitting the rounded areas at the ends of the tangs is most easily done with a "Dremel"- type rotary tool - but be careful! It can easily get away from you, quickly ruining your work. A much safer method is to use a small, rounded carving tool, available from a hobby or craft store. This will allow you to widen the tang inletting without cutting a groove along the bottom. If possible, use one that is "safe" on one edge (no teeth). While many specialized files may be used to great advantage, the one most often needed is a common flat, bastard cut file (included in our Deluxe Stock Finishing Kit). The single most important tool you will need is a file. Very few tools are required to properly fit PGW's semi-finished stocks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |